Main page » Components » Parts for Amps » Reverb Tanks » Reverb Tanks » Accutronics Reverb Tank 9AB2C1B

Preview: Accutronics Reverb Tank 9AB2C1B

Accutronics Reverb Tank 9AB2C1B

Mobile Preview: Accutronics Reverb Tank 9AB2C1B

Description

Springs: 3
Delay Type: medium
Size: long
Replacement: Fender, Mesa Boogie
Accutronics by Accu-Bell, Made in Korea

Manufacturer

Herstellerinformationen | Manufacturer Information
Accu-Bell Sound Inc.
Room #1307
Hanlla Sigma Valley
345-90 Gasang-Dong
Geumcheon-Ku, Seoul
Korea
http://www.accutronicsreverb.com/

EU-Wirtschaftsakteur | EU Economic Operator
Tube-Town GmbH, Rumbergring 37, 66969 Lemberg, Germany, info@tube-town.de

Customer reviews

Essential information about customer reviews We do not verify that the published reviews come from such consumers who have actually used or purchased the rated goods or services. All reviews, i.e. positive and negative, are published. No reviews that are unobjective, offensive or unrelated to the product will be published.

Unfortunately there are no reviews yet. Be the first who rates this product.

Recommended products:

Rubber Grommet for Reverb Tank, 4 pcs

Rubber grommets for reverb tanks, package of four.
Mounting Hole Diameter = 3/8"
Outer Diameter = 1/2"

1,70 €

Customers who bought this product bought also the following products:

EH 7025 (12AX7 / ECC83 HQ) - Balanced

TT Selection: Balanced
Both systems with balanced gain

Electro-Harmonix has released a low noise, low microphonic version of the 12AX7 that meets all specifications required for the tube to be designated 7025. The original 7025 tube was a 12AX7 that was tested and selected for the lowest noise and microphonics for use in the critical first preamp stages of amplifiers where noise and microphonics could be an issue. In order to ensure that the 7025 specification is consistently met, Electro-Harmonix has redesigned the structure of the 12AX7 and has implemented construction techniques to ensure the absolute lowest noise and microphonics possible. In all samples tested, noise and microphonics could not be detected.

The Electro-Harmonix 7025EH has a mid-range that gives clarity and definition to the sound and a smooth top end for warmth and balance. With these characteristics, along with the exceptionally low noise and low microphonics, the Electro-Harmonix 7025EH will work equally well in vintage and modern high-gain guitar amplifiers, as well as sensitive phono preamps.

25,80 €

JJ EL84 #05 - Fender Blues Junior

JJ EL84 #05 - Soft Plus

Not so hot than the #06 selection but still nice punch
Recommended for Fender Blues Junior and Pro Junior and similar amps.
Price for one tube.

FAQ: If I order two or more of these tubes, are they all "the same"?
Yes, the tubes are all "matched" and selected for the in the description mentioned amplifier.
FAQ: Can I replace the tubes myself or are adjustments needed?
Adjustments are not possible on the listed amplifier (unless a bias potentiometer has been added afterwards). The replacement can therefore be done without adjustments.

18,00 €

JJ 6V6 Red Labe - QUAD - Double Mica

4 tubes, matched as quad

JJ 6V6 Double Mica double-layered mica in the upper part of the tube. This stabilizes the tube system and significantly reduces possible vibrations that can occur due to heavy mechanical stress. This version of the JJ 6V6 was specifically designed for use in combo amplifiers.

The JJ6V6 is a beam power pentode with octal base and a maximum plate dissipation of 14W. It has fat low end and full mid tones with very good tone separation and a smooth, clean high end - in general, a very balanced tone.
Currently, the only new production 6V6 which is approved for up to 500V anode voltage in pentode operation.

Files:

Datasheet

110,00 €
27,50 € per Piece