Main page » Tubes » JJ-Electronic » JJ EL84 #05 - Fender Blues Junior

JJ EL84 #05 - Fender Blues Junior

Description

JJ EL84 #05 - Soft Plus

Not so hot than the #06 selection but still nice punch
Recommended for Fender Blues Junior and Pro Junior and similar amps.
Price for one tube.

FAQ: If I order two or more of these tubes, are they all "the same"?
Yes, the tubes are all "matched" and selected for the in the description mentioned amplifier.
FAQ: Can I replace the tubes myself or are adjustments needed?
Adjustments are not possible on the listed amplifier (unless a bias potentiometer has been added afterwards). The replacement can therefore be done without adjustments.

Manufacturer

Herstellerinformationen | Manufacturer Information
JJ Electronic
A. Hlinku 3
022 01 ČADCA
Slowakische Republik
www.jj-electronic.com

Customer reviews

Essential information about customer reviews We do not verify that the published reviews come from such consumers who have actually used or purchased the rated goods or services. All reviews, i.e. positive and negative, are published. No reviews that are unobjective, offensive or unrelated to the product will be published.

Unfortunately there are no reviews yet. Be the first who rates this product.

Needed for:

JJ EL84 / 6BQ5 Red Label - QUARTETT

4 tubes, matched as quad

JJ EL84 / 6BQ5 Red Label

Files:

Datasheet

65,80 €
16,45 € per Piece

JJ EL84 / 6BQ5 Red Label - PAIR

2 tubes, matched as pair

JJ EL84 / 6BQ5 Red Label

Files:

Datasheet

32,90 €
16,45 € per Piece

Customers who bought this product bought also the following products:

TT Potentiometer 16 mm 25k log

TT Potentiometer Made by Alpha

Electrical Characteristics

Total Resistance Tolerance: +/- 20%
Rated Power
- B/Lin Taper: 0,125 W
- A/Log Taper: 0,1 W
Max. Operating Voltage
- B/Lin Taper: 150 V AC
- A/Log Taper: 150V AC
Noise: 47 mV max.
Insulation Resistance: 500 V DC 1000MOhm
Withstand Voltage: 1 minute 500 V AC
Rotational Life: 15000 Cycles

Mechanical Characteristics

Shaft Diameter 6 mm
Shaft Type: Split Shaft
Shaft Length: ca. 9 mm
Bushing Length: 6,5 mm
Body Diameter: 16 mm
Connectors: Solder Lugs
Total Rotational Angle: 300° +/- 5°
Rotational Torque: 30~200gf.cm
Solder Heat Resistance: 300°C, 3 S

Material

Shaft: Cast Iron (Aluminium Zinc)
Bushing Material: Cast Iron

0,75 €

EH 7025 (12AX7 / ECC83 HQ)

Electro-Harmonix has released a low noise, low microphonic version of the 12AX7 that meets all specifications required for the tube to be designated 7025. The original 7025 tube was a 12AX7 that was tested and selected for the lowest noise and microphonics for use in the critical first preamp stages of amplifiers where noise and microphonics could be an issue. In order to ensure that the 7025 specification is consistently met, Electro-Harmonix has redesigned the structure of the 12AX7 and has implemented construction techniques to ensure the absolute lowest noise and microphonics possible. In all samples tested, noise and microphonics could not be detected.

The Electro-Harmonix 7025EH has a mid-range that gives clarity and definition to the sound and a smooth top end for warmth and balance. With these characteristics, along with the exceptionally low noise and low microphonics, the Electro-Harmonix 7025EH will work equally well in vintage and modern high-gain guitar amplifiers, as well as sensitive phono preamps.

19,80 €