JJ E34L - PAIR

Vacuum Tube Damper made of silicon, helps to reduce noise and rattle of vacuum tubes. But it will not turn a bad tube into a good tube.
If a higher level of damping is needed, than use more than one damper per tube.

• Inner diameter ca. 32 mm
• Use tt-da15 for EH EL34
• Price per damper

BEFORE ordering check the exact outer diameter of the vacuum tubes and compare it with the diameter of the damper to make sure that the damper fits.

PVC piping for baffles and cabinet front panels

• Size 5 x 14 mm
• 4 m piece

Set of componentes for building the TT 5E3 / Tweed Deluxe Guitar Amp.
Please visit the >>Project page for more infos about the amp, schematics and layout.

INCLUDED:

• Transformers (Hammond 1760E und 290BEX)
• Resistors
• Capacitors
• Jacks
• Light
• Wires
• Board
• Switches
• Tubes
• Fuses & Fuesholder
• CHASSIS

NOT INCLUDED:

• Knobs
• Headshell or Combo

To build this project knowledge in electric engeneering, experience with high voltage, and the reading and understanding of schematics and dealing with measurement device is highly recommended .
There is NO step-by-step guide for beginners. The circuit and layout plan includes all relevant information. If you don't understand it then don't build it.
THIS IS NOT A BEGINNERS PROJECT !

• Type: Chickenhead
• Material: Phenolic
• Shaft Size: 6 - 6,3 mm
• Size: 32 x 13,7 mm
• Mounting: Set-Screw

Lemberg 020 Headshell Flatpack
For all chassis of the LoW-Series WITHOUT side mounting brackets.
This flatpack is made of high quality, 15 mm birch multiplex, is completely CNC milled and drilled and very easy to assemble.

For the assembly you need

• Wood drill 5 mm
• Cross-head screwdriver or cordless screwdriver (recommended)
• Wood glue (NOT included in delivery)

The surface of the assembled headshell can be treated as desired. We recommend to oil it, because this is a very simple but effective procedure. However, it can also be painted or covered with Tolex (in which case the width of the front panel may need to be reduced) or otherwise treated.
Furthermore, corners, handles and rubber feet can be added according to your taste and need. Suitable accessories are listed in the accessories list under the product description here.

Files

• Assembly Instruction

Specifications

• Size (WxHxD): 318 x 190 x 215 mm (Outside)
• Hardware: Screws are included.
• Wood: 15 mm Birch Plywood

[content:3210136]

Desoldering pump for removing soldering tin, non-static, dimensions: 230mm x 25mm. EXTRA STRONG.

Powerswitch for Marshall JCM Series

• lighted red
• 20 A / 125 V AC
• 16 A / 250 V AC
• DPST ON-OFF
• Recess: 28.5 x 22 mm
• solder-lugs and quick connect terminals

• Type: Powerswitch, Marshall JCM Series
• Rating: 250 V AC @ 20 A
• Version: DPST, ON-OFF
• Recess: 28.5 x 23 mm, Snap-in mount
• Termination Style: solder-lugs, quick connect terminals

• Output-Transformer Push-Pull
• for JCM800 / JMP 50 Watt
• Pri: 3200 Ohm / CT
• Sec: 4, 8, 16 Ohm
• Power: 50 Watt

Files:

• Datasheet