Fender Blues Junior 25 kOhm lin - Middle
Fender Blues Junior 25 kOhm lin - Middle
Fender Blues Junior 25 kOhm lin - Middle

Fender Blues Junior 25 kOhm lin - Middle

Product No.:
fe004-9402
In stock for immediate delivery. Delivery time depends on the destination country* In stock for immediate delivery. Delivery time depends on the destination country*
RoHs:
conform
Weight:
0.01 kg per piece
6,25 €

incl. VAT excl. Shipping costs

Bookmark
Ask Question
Description

Fender Blues Junior Potentiometer
004-9402-000

Manufacturer
Herstellerinformationen | Manufacturer Information
Fender Musical Instruments Europe GmbH
Königsallee 80
40549 Düsseldorf
Germany
http://www.fender.com/
Customer reviews

Essential information about customer reviews We do not verify that the published reviews come from such consumers who have actually used or purchased the rated goods or services. All reviews, i.e. positive and negative, are published. No reviews that are unobjective, offensive or unrelated to the product will be published.

Unfortunately there are no reviews yet. Be the first who rates this product.

Customers who bought this product bought also the following products:

F+T 47 µF @ 450 Volt, axial
F+T 47 µF @ 450 Volt, axial
  • Type: Aluminum Electrolytic Capacitors
  • Capacitance: 47 µF
  • Voltage Rating: 450 V
  • Tolerance: - 20 % / +20 %
  • Operating Temperature Range: - 40°C / + 85 °C
  • Dimensions: Ø 18 mm x 39 mm
  • Termination Style: axial
2,80 €

JJ EL84 #05 - Fender Blues Junior
JJ EL84 #05 - Fender Blues Junior

JJ EL84 #05 - Soft Plus

  • Not so hot than the #06 selection but still nice punch
  • Recommended for Fender Blues Junior and Pro Junior and similar amps.
  • Price for one tube.
FAQ: If I order two or more of these tubes, are they all "the same"?
Yes, the tubes are all "matched" and selected for the in the description mentioned amplifier.
FAQ: Can I replace the tubes myself or are adjustments needed?
Adjustments are not possible on the listed amplifier (unless a bias potentiometer has been added afterwards). The replacement can therefore be done without adjustments.
18,00 €

EH 7025 (12AX7 / ECC83 HQ)
EH 7025 (12AX7 / ECC83 HQ)
Electro-Harmonix has released a low noise, low microphonic version of the 12AX7 that meets all specifications required for the tube to be designated 7025. The original 7025 tube was a 12AX7 that was tested and selected for the lowest noise and microphonics for use in the critical first preamp stages of amplifiers where noise and microphonics could be an issue. In order to ensure that the 7025 specification is consistently met, Electro-Harmonix has redesigned the structure of the 12AX7 and has implemented construction techniques to ensure the absolute lowest noise and microphonics possible. In all samples tested, noise and microphonics could not be detected.

The Electro-Harmonix 7025EH has a mid-range that gives clarity and definition to the sound and a smooth top end for warmth and balance. With these characteristics, along with the exceptionally low noise and low microphonics, the Electro-Harmonix 7025EH will work equally well in vintage and modern high-gain guitar amplifiers, as well as sensitive phono preamps.
19,80 €

JJ 12AX7 / ECC83S
JJ 12AX7 / ECC83S

Sweet and warm sounding preamp tube with high gain. We recommend this tube for guitar/bass amps.

Files:

16,90 €

Silicon Tube Damper for 12AX7, EL84
Silicon Tube Damper for 12AX7, EL84
Vacuum Tube Damper made of silicon, helps to reduce noise and rattle of vacuum tubes. But it will not turn a bad tube into a good tube.
If a higher level of damping is needed, than use more than one damper per tube.
  • Inner diameter ca. 22 mm
  • Can not be used with JJ 12AX7 and other JJ preamp tubes with similar diameter and JJ EL84 and JJ EL844
  • Price per damper
BEFORE ordering check the exact outer diameter of the vacuum tubes and compare it with the diameter of the damper to make sure that the damper fits.
0,45 €

F+T 32 + 32 µF / 500 V Multisection
F+T 32 + 32 µF / 500 V Multisection
  • Type: Multisection Capacitor
  • Capacitance: 32 + 32 µF
  • Voltage Rating: 500 V
  • Tolerance: - 10% / +30 %
  • Operating Temperature Range: - 40°C / + 85 °C
  • Dimensions: Ø 35 mm x 50 mm
  • Termination Style: radial, solder lugs
8,30 €

Silicon Tube Damper for 6V6
Silicon Tube Damper for 6V6
Vacuum Tube Damper made of silicon, helps to reduce noise and rattle of vacuum tubes. But it will not turn a bad tube into a good tube.
If a higher level of damping is needed, than use more than one damper per tube.
  • Inner diameter ca. 28 mm
  • Price per damper
BEFORE ordering check the exact outer diameter of the vacuum tubes and compare it with the diameter of the damper to make sure that the damper fits.
0,65 €

Silicon Tube Damper for 6L6
Silicon Tube Damper for 6L6
Vacuum Tube Damper made of silicon, helps to reduce noise and rattle of vacuum tubes. But it will not turn a bad tube into a good tube.
If a higher level of damping is needed, than use more than one damper per tube.
  • Inner diameter ca. 34 mm
  • Price per damper
BEFORE ordering check the exact outer diameter of the vacuum tubes and compare it with the diameter of the damper to make sure that the damper fits.
0,65 €

Teslanol Contact spray T6, 200 ml
Teslanol Contact spray T6, 200 ml
Kontaktspray - 200 ml

The T6-Oszillin contact cleaner is specially formulated to clean both fine and coarse mechanical components. This 200 ml spray is designed to repel water and prevent moisture-related ignition issues in items such as batteries or motors. It improves the conductivity of switches, relays, and contacts, providing long-lasting protection. Additionally, it safeguards damaged precious metal layers from corrosion and removes old, hardened lubricants such as oils and greases without leaving any discoloration thanks to its colorless and odorless formula.

Specifications
  • Volume: 200 ml

Attention: No shipping with FedEx possible.

Files:


 

4,85 €

Silicon Tube Damper for EL34, KT77
Silicon Tube Damper for EL34, KT77
Vacuum Tube Damper made of silicon, helps to reduce noise and rattle of vacuum tubes. But it will not turn a bad tube into a good tube.
If a higher level of damping is needed, than use more than one damper per tube.
  • Inner diameter ca. 32 mm
  • Use tt-da15 for EH EL34
  • Price per damper
BEFORE ordering check the exact outer diameter of the vacuum tubes and compare it with the diameter of the damper to make sure that the damper fits.
0,65 €

Strap-Handle Fender Vintage, brown
Strap-Handle Fender Vintage, brown
Fender Strap Handle
  • Fender #0990944000
  • Plastic covered with steel inner core
  • End plates: Steel, nickel plated
  • Color: Brown
  • Mounting hardware: Screws and t-nuts included
19,80 €

Bourns Potentiometer GTR 250k log Knurled Split Shaft
Bourns Potentiometer GTR 250k log Knurled Split Shaft
Bourns Guitar Potentiometer
  • Power Rating: 250 mW (1/4 W)     
  • Voltage Rating: 250 V     
  • Tolerance: 20 %     
  • Termination Style: Solder Lug     
  • Element Type: Carbon    
  • Shaft Diameter: 6,3 mm
  • Shaft Type: Knurled Split Shaft
4,40 €

Knob Chickenhead Mini black
Knob Chickenhead Mini black
  • Type: Chickenhead, Mini
  • Material: Phenolic
  • Shaft Size: 6 - 6,3 mm
  • Size: 22.75 x 18.7 mm
  • Mounting: Set-Screw
0,80 €

Knob Chickenhead black
Knob Chickenhead black
  • Type: Chickenhead
  • Material: Phenolic
  • Shaft Size: 6 - 6,3 mm
  • Size: 32 x 13,7 mm
  • Mounting: Set-Screw
0,90 €

F+T 22 µF @ 450 Volt, axial
F+T 22 µF @ 450 Volt, axial
  • Type: Aluminum Electrolytic Capacitors
  • Capacitance: 22 µF
  • Voltage Rating: 450 V
  • Tolerance: +/- 20%
  • Operating Temperature Range: - 40°C / + 85 °C
  • Dimensions: Ø 16 mm x 30 mm
  • Termination Style: axial
2,45 €