Surf at the maximum !
Set of componentes for building the TT Surfmate. Please visit the >>Project page for more infos about the amp.
INCLUDED:
- Transformers (Power and Output)
- Resistors
- Capacitors
- Jacks
- Light
- Wires
- Board
- Switche
- PSU
- Tubes
- Fuses & Fuesholder
NOT INCLUDED:
- Knobs
- Chassis
- Faceplate
- REVERB TANK
To build this project knowledge in electric engeneering, experience with high voltage, and the reading and understanding of schematics and dealing with measurement device is highly recommended .
There is NO step-by-step guide for beginners. The circuit and layout plan includes all relevant information. If you don't understand it than don't build it.
So I'm not an electronics engineer, I don't make tube amps a dime a dozen and this assembly is my first experience on high voltage.
But be careful, you have to know how to read a minimum a diagram to follow its wiring, have a good iron, desoldering pump, a serious multimeter, …
The project is an assembly of several kits, the photos of the site are very useful in case of doubt, I have not had any particular problems, if you are a little meticulous and patient and you constantly recheck the value of each component before soldering, the project is done without difficulty.
With this kit and the dedicated cab, we have plenty to enjoy in the assembly, in the aesthetic and sound results, which is frankly superb.
I recommend ! on high voltage.
But be careful, you have to know how to read a minimum a diagram to follow its wiring, have a good iron, desoldering pump, a serious multimeter, …
The project is an assembly of several kits, the photos of the site are very useful in case of doubt, I have not had any particular problems, if you are a little meticulous and patient and you constantly recheck the value of each component before soldering, the project is done without difficulty.
With this kit and the dedicated cab, we have plenty to enjoy in the assembly, in the aesthetic and sound results, which is frankly superb.
I recommend !
go to post