Wire Silicon 0,5 mm² - yellow

Carbonfilm Resistor
Low noise, small size, high power rating
Power: 1 Watt
Voltag: 500 V working / 1000 V overload
Axial Leads
-55° C - 155° C
12 * 5 mm
RoHS

Carbonfilm Resistor
Low noise, small size, high power rating
Power: 1 Watt
Voltag: 500 V working / 1000 V overload
Axial Leads
-55° C - 155° C
12 * 5 mm
RoHS

• up to T 70 °C
• with one fuse holders 5.0 x 20 mm
• Housing: polyamide
• UL 94 V-0, black
• for panel mounting
• Double-pole + protective ground 10 A/250 V
• single-pole fusing with bridge to the fuse holder at the L terminal
• fuse holder terminals for soldering
• Design to IEC/EN 60320-1
• fuse holder to IEC/EN 60127-6
• Certifications: ENEC, Semko, UL, CSA

• Pri: 0-2k5-5k Ohm
• Sec: 4-8-16 Ohm
• Max DC Current: 160 mA
• Power: 15 W

Files:

• Datasheet

• Type: Pointer Knob "Classic"
• Material: Phenolic
• Shaft Size: 6 - 6,3 mm
• Size: 27 x 15,6 mm
• Mounting: Set-Screw

Carbonfilm Resistor
Low noise, small size, high power rating
Power: 1 Watt
Voltag: 500 V working / 1000 V overload
Axial Leads
-55° C - 155° C
12 * 5 mm
RoHS

Carbonfilm Resistor
Low noise, small size, high power rating
Power: 1 Watt
Voltag: 500 V working / 1000 V overload
Axial Leads
-55° C - 155° C
12 * 5 mm
RoHS

• Type: Metalized polypropylene film Capacitors
• Capacitance: 22 µF
• Voltage Rating: 630 V
• Tolerance: - 5% / +5 %
• Operating Temperature Range: - 25°C / + 85 °C
• Dimensions: Ø 40 mm x 58 mm
• Termination Style: axial
• Small size
• self-healing
• non inductive

These axial capacitors are specially appreciated for their high sonic performances.

• Type:Toggle Switch
• Version:SPST, ON-OFF
• Rating: 3A / 250V, 6A / 125V
• Insulation resistance: 100MΩ min.
• Dielectric strength: 1000V min.
• Operating Life: 25.000 cycles
• Drill Ø: 12 mm
• Termination Style: solder-lugs

• Heavy duty construction walnut chassis
• Top panel available in a choice of natural aluminum or satin black powder paint finish
• Walnut chassis is 0.778 inches thick (19.8 mm) - corners are produced with wood bracing & dovetail construction methods. Designed to handle heavy components
• Top panel is aluminum for easy modification and thick enough to support heavy transformers without bowing - 0.08" (2 mm) thick. Fully "framed" support from walnut chassis
• Includes four large round rubber feet (0.75" dia. x 0.56" high) with mounting hardware into inserts to avoid wood damage. Hardware is of proper length to allow use of optional bottom plate
• ATTENTION: no bottom plate included. The bottom plate needs to get ordered additionally if desired

Files:

• Datasheet