Universal size for 12" speakers
Dome diameter: 80 mm - recommended for most of the guitar loudspeaker with average beaming

As the frequency increases, the radiation of a loudspeaker is increasingly focused on its center. If the listener is in this beam, the sound is extremely harsh and biting; if one moves to the side of it, the sound becomes significantly darker and treble components are partially missing.
To reduce this behavior, a diffuser is used. This sits directly in the beam of the speaker and deflects the high frequencies very strongly, it breaks the "beam". This makes the sound much fuller and more balanced.

Width: 30 mm, bright China bristles with wood handle

ideally for the Tolex Glue SG5

Flat Cable-Plug, Cable Shoe, crimp connection for width max 5,2 x 0,5 mm
Pack of 10 pcs

• Mixed sizes, length 10 cm / ea, black

• Insulation: Silicon
• Operation Voltage: 300 V AC / 500 V DC
• Packing: 5 m

• Insulation: Silicon
• Operation Voltage: 300 V AC / 500 V DC
• Packing: 5 m

• Type:Toggle Switch
• Version:DPDT, ON-OFF
• Rating: 10A @ 250VAC, 15A @ 125VAC
• Insulation resistance: 100MΩ min.
• Dielectric strength: 1000V min.
• Operating Life: 25.000 cycles
• Drill Ø: 12 mm
• Termination Style: Terminal

Knob Fender Style Vintage

• Material: Phenolic
• Shaft Size: 6 - 6,3 mm
• Size: 20,3 x 11,8 mm
• Mounting: Set-Screw with Bras insert

TT Selection: V1 - Low Noise
This tube is selected for sensitive input stages (V1)

The TT12AX7 impresses with its fine and detailed reproduction of the highs, which is maintained even at high amplification levels. Due to a higher H3 part, the TT12AX7 sounds significantly cleaner than many other 12AX7/ECC83 tubes, which makes the bass range appear much tighter. We therefore especially recommend this tube for styles such as clean, crunch, and metal, where high amplification and clear transparency are required.

Rectifier
An indirectly heated diode intended for rectification of commercial-frequency alternating current. It has a 140 mA maximum output and filament voltage of 5 V and a filament current of 2 A +/- 0.2 A.