Alpha Potentiometer 1 MOhm linear / 16 mm

Hex nut for Alpha Potentiometer series APO-PCB16 and similar, Alpha Item Number HZ92-7-AF

• Size: M7 x 0,75 mm
• Price per nut

• Type: Noval Socket
• Version: Ceramic Chassis mount
• w/ mounting bracket
• Termination Style: solder lugs
• for Tube Type: 12AX7, 12AT7, 12AU7, EL84, EZ81, EL844 etc.

• Type: Synth Pointer
• Material: Phenolic
• Shaft Size: 6 - 6,3 mm
• Size: d=16 mm, h = 11,8 mm
• Mounting: Set Screw, Brass Insert

• Type: Synth Pointer
• Material: Phenolic
• Shaft Size: 6 - 6,3 mm
• Size: d=16 mm, h = 11,8 mm
• Mounting: Set Screw, Brass Insert

Pointer Knob "Classic"

• Material: Phenolic
• Shaft Size: 6 - 6,3 mm
• Size: 19 x 14,5 mm
• Mounting: Hexagon Set Screw

made of nickel-plated brass
with M3 thread
Hole diameter: 3.2 mm
Dimensions: 10 x 11 mm

made of nickel-plated brass
Hole diameter: 3.2 mm
Width: 15 mm

made of nickel-plated brass
Hole diameter: 3.2 mm
Width: 10 mm

Cliff 1160 mono jack, vintage-style

• Jack socket, mono
• switched
• for chassis mounting, 4 solder terminals
• for 6.3 mm jack plug
• Used by Marshall and many others

Files

• Datasheet

waterbased Tolex-Glue, 500 ml

How To use ?
The glue must be applied onto the wood and the Tolex.
After a dyring time of ca. 30 min the Tolex can be put onto the wood.

And how much glue do you need ?
The can of 500 ml is enough for ca. 2.3 m². This is enough for a TTC212REX and there is still about 100 ml glue left.

Attention
For a better adhesive power it is recommended to put a second layer of glue onto the tolex after the drying time.

Files:

• Safety Datasheet

The LNDVerb kit is based on a classic Fender reverb circuit, but uses LND 150 Mosfets instead of tubes. These can be operated at voltages as high as 500 V, to get as close as possible to the characteristics of real tubes.

The kit can be integrated into an existing amplifier or can be build as standalone unit like the Fender tube reverb.

The unit needs less than 10 mA current, so a VPump for example can be used as power supply in a standalone build. If it gets integrated into an existing amplifier the already present power supply of the amp can be used to supply the needed voltage for the unit without the need to upgrade the power transformer.

A reverb transformer of the type 125A20B or similar and a reverb tank are necessary to operate the LNDVerb. These are both not included in the kit.

The needed RCA phone sockets and potentiometers are included in the kit.

Further informations and examples of the finished unit can be found in the PDF below.

Matching parts are linked below and can be ordered with the unit if needed.

Files:

• Datasheet